67in brushed nickel barn door hardware. Only hardware for sale, Door panel is not included. 2pcs Rollers can hold 1 door panel Max weight 198lbs(90kg). Roller suitable for door panel thickness:1-3/8" to 1-3/4".
67in track can be used for door panel width up to 33.5. Our track pre-drilled 16" apart holes, can be used for 16" apart studs wall. Do not install directly onto drywall or other hollow wall. Such surfaces are not strong enough to support the total active weight of the track and door. Every fastener used to attach the track to the wall must be fastened securely into a structural surface.Make sure the length from top of the door to the ceiling is longer than 5-7/8 for installation. If the frame thicker than 1/2, remove the frame mouldings to minimize door undercut. If you do not remove them, use extra spacers(not included) or install a piece of wood (not included) of the same thickness and length as the mouldings before installing the new hardware to ensure door undercut. Drill holes on the door panel. First center hole to the top of the door:1-9/16. Center length between two holes:3-9/16. Note: Door panel need cut a groove for floor guide. 2pcs rollers and floor guide will be a triangle to keep door panel straight and not swing during sliding. 2pcs anti-pad installed on the top of the door can reduce gap between door and track in case rollers fall off from track, please use them for safety reason.
The item "DIYHD Brushed Nickel Stainless Steel Sliding Barn Door Track Hardware" is in sale since Wednesday, October 10, 2018. This item is in the category "Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Other Door Hardware". The seller is "sliding-barn-door" and is located in Milton, ON. This item can be shipped to Canada.